Ford Focus ST225 MK2 FL
Engine code: HYDA
Stock engine without internal modifications. The only modification to the engine hardware is a replaced downpipe without a catalytic converter.

The map was calibrated on a dynamometer:
    Peak power: 260 HP
    Peak torque: 461 Nm
    Peak boost pressure: 100 kPa (1.0 bar)

Setup Details:
   EMU BLACK (V3 firmware 3.066) + Ford Focus MK2 adapter (include accelerator position sensor adapter)


The attached map controls the following:
   CAN stream for Ford Focus ST MK2
   Per cylinder knock control
   Variable valves timing
   Electronic throttle
   Air conditioning
   Oil pressure switch
   Reverse gear lock
   Low-pressure fuel pump
   Pneumatic wastegate
   PWM radiator fan
   Starter relay
   Main relay

Mapped for stock car parts:
   Traction control

Mapped for stock engine parts, disabled in the map:
   Launch control
   Anti-lag system
   Flat shift
   Rev matching


__Treat this base map as a baseline for further refinement. __
It is critical to verify all assigned outputs and ensure they match your wiring. In the software, go to “Tools / Assigned outputs” and “Tools / Assigned inputs”. If the assignments do not match, do not load the map to your ECU. Adjust the outputs as necessary before proceeding. 
		
**Revision history:**
`2026/07/01` v1.0 Initial release