Ecumaster forum

Zach, Frimware is the 1.1Rc1 I will upload the scope data It seems to sync when it wants .....some times it syncs right away, sometimes it never syncs and cranks and cranks and cranks The Vr sensors are good the engine started and ran fine on the OEM ecu Battery Voltage is 12.3-12.9 When Cranking I ...

Well I think im ok with the flooding problem, dialed the tables way back and its starting now rough I have to fight with it but it starts ... but it still takes forever to sync like 3-5 seconds of cranking if im lucky.... sometimes it never syncs... ......new question why does it take forever to syn...

the configurable outputs are not connected to anything yet.....
and 1-5-3-6-2-4 ? for the ignition events

This is the Map
im not sure what I missed
Just need to get it starting consistently to get it to my tuner

ihiryu Does your customers Sync right away? it seems like mine turns over and over and over syncs then I get a sputter a backfire and it almost sounds like its out of time ? but when It syncs right away it sometimes starts and idles for a second or so you can even rev till it dies so I don't think i...

The main relay?!?!?!?!? ...Yeah that probably does seem dumb haha.... emu ignition , coils ,and injectors are on toggles ,Sorry should have said that... but I know for a fact that everything is getting power. Coils are: Denso LS1 coils (built in transistor) in full sequential. There 4 pin (+12 ign,+...

The wires are 2 conductor foil jacket shielded in there own insulation the shield is grounded to (B17)EMU ground at one end and the Negative of the VR sensor is connected to Sensor ground (B18) roughly 4 inch away from the EMU connector ...I tried to keep it shielded as far as I could...... Well tho...

Firing order is 1-5-3-6-2-4 I had done some reading I had done in the manual and on the forum, and from what I understood it has to sync before it will deliver fuel and spark? That's why im chasing this Sync problem I am getting neither spark or fuel. I have looked at the wiring ,all wires are in th...

This is the Scope Data

Hey Guys Im having a problem getting my Cam/Trigger to sync. I have checked wiring, both wires are shielded and grounded at one end. Trigger: VR Sensor Toothed wheel 2 missing teeth Edge- Falling CYL-6 Teeth-36 T angle-63 Secondary Trigger: VR Sensor 2jz vvt 3 Teeth Edge Falling I have scoped the Si...