Ecumaster forum

I Would use the Signal from the dash, also the differential Sensor. I Think The Signal are the Same.

Car has no ASC .

Tim

I have the same Problem,
maybe im not the electrical pro
But i would use se speed signal on my E36, which setup i must use to became a signal!?!

its an E36 from 1997


best ragards an thanks for help!

But for Dual fire i must connect the Coils in other configuration, or can i configured it in the EMU?

I only see cyl 1+2, 3+4, 5+6 not the pair 1+6 5+2 etc.

I despair

And i use VAG RED 115 Coils

Can you take a look over my basemap?

I test it all, but it is not starting

M50B28 NV complete build up for Turbo.

only m52 part is the trigger wheel and the crankshaft.

its only a map to start, an rolling with max 2500rpm for check all the motor parts and looking for leaks.

Thanks a lot.
I Hope it will Starts tomorrow, the Rest Is all corectly configured.

Best regarts.

Hello , I hope that everyone can help me, I build a M50 NV Turbo an have Logic Problems with the trigger Setup. The M52 Wheel have the 2 missing tooth 324deg After TDC But what i have to tipe in the EMU ? I have tip in From top toll Bottom in the trigger Setup - VR Sensor - Enable Pullup yes - 2 mis...

Can you give me an complete dwell time setup for the RED 115E Coils
for the complete Volt Range?

It is for an M50B25 with the R8 Coils.
thanks a lot

best ragarts,

tim

Hello, my Name is Tim from Germany. I Would like to run a "small" LCD Display like Vems,KMS etc to install it into the dash.So it is not so visible from the outside, a little bit understatement ;) I'm not a fan to run a Android phone or run a seccond Lambdacontroller or Boostgauge or something in th...