Ecumaster forum

Is there a way or maybe future update to fix afr targets in log , I make very good log but my afr targets were set to 14.7 since I do not use close loop and now want to test autotune but can not modify aft targets What do you mean by fix AFR target in log ? By the time I made the log the whole afr ...

Is there a way or maybe future update to fix afr targets in log , I make very good log but my afr targets were set to 14.7 since I do not use close loop and now want to test autotune but can not modify aft targets

I think it should be Ok , it there are problems again please share log and emu file

What is this filter for oxygen sensor ?

What gives changing pump kp ki kd and integral limit ?

First why you do not use original firing order 1 5 3 6 2 4 ? I make you a picture when you can fire injectors , I use the one on bottom but first is good too as my knowledge so if you use first your injector phasing must be : first one with blue injection : injector phases from 1 to 6 injector - 5 3...

The question is about clear log ? I can make video if you want - tomorrow

v1.32exp1 on 2 laptops and 2 different cars when push Clear Log and emu freeze and shut down

I see the formula for enrichments - Acc enrichment = Dtps rate * RPM * TPS factor * Clt factor - can you give me example with real numbers and how to use result as % or PW ? for example - ACC = 110 * 65 * 70 * 100 ( not used clt factor ) .

Thanks will try

I can lower the values but it is calculation I do not think that there is problem of that , problem is why at gear ratio 52 it shows 1st gear which is not nearest one

I was looking in my logs from today and see that there is problem with gear detection , as you see in screenchot gear ratio is 52 ( 60 +/- 10% ) for fort gear ) but it shows 1st gear

From my tests 30 degrees in IAT ( from 10 to 40 degC ) there is 10 % change in fuel

I use Perf Expert software - virtual dyno with 1:1 results as chasis dyno

Yes it works in this way , but I have too much noise on hall signal using pullup in Emu , bmw have square wave signal from instrument cluster but it is pulled up with 12volts , can it be used with emu ?

In log there is button channel config , whatever I put for maximum or minimum value it do nothing when I push OK button and the only way to close the menu is by cancel

Same here

Please add in launch control menu an option for Tps maximum point from which up the LC if off , I need that to deactivate LC when see that tires have grip and wot ...

Marab wrote:hello. Please advice.
android software works, bluetooth connects, but only shows the value rpm. which may be a mistake?

In emu software - EXt. port / General / Ecumaster serial protocol

There is problem conecting with dropbox to download fitmware

Ignition 6 is G1 not G14