Ecumaster forum

you can download the latest software/firmware here: http://www.ecumaster.com/testVersions.html

I reflashed the firmware and using 5V pullup, I manage to get the engine running.
Now, using DET3,the engine only manage to rev till around 4500rpm and it behave as if
it is having the launch control set on.

i scoped the input vs output through DET3 and i found that there are no waveform at the output hence the no start condition.

I just tested the new firmware (1.30) with 36-2-2-2 trigger pattern. Sadly to let you know that the engine failed to start with it. I can't test with DET3 FI because the trigger pattern is not found in it.
Anything that I can do to help?

great news. i will give it a try.

Jadzwin wrote:We have lots of request for this trigger type, so we decided to add it to the DET3.
It should be available in about one week.

Any development on this yet?

just to confirm that it works but without the tracing cursor I still need that table to refer.

thanks. I'll give it a try.

that will be great. happy to hear that.

sorry, I reverted to 103 without taking any logs.
the car belong to a customer and I don't think that I can replicate that in near time.
however, the wbo freezes when using 1055 for sure since I waited a few minutes
and nothing happened.

I hope that Subaru/rx7/rx8 trigger can be supported.
it is using 36-2-2-2 trigger pattern with 8500 rpm limit.

while the software have the option to display tables and/or 3D graph, we can only tune using the table.
I hope the 3D graph can also be use as well.

using 1.055 firmware, the AFR gauge tends to stop working.
I reverted to 1.031 and the gauge works again.