Ecumaster forum

Did you manage to fix the DET3 on your car?

Hi All, I would firstly thank ECU Master Technical team for their continued support. I would like to share my experience with ECU master EMU used on Suzuki G series wasted spark ignition system. Vehicle Specification Make : Maruti Suzuki Model : Esteem MK 1 (globally know as Suzuki Swift) Engine Cod...

Since now there is no trigger in DET3, that would work with cam sensor. Probably subaru type of ignition trigger would work with crank signal and crank wheel from Baleno/Wagon r+. This version is without Dizzy and it comes with CAM and CRANK sensor below image is the reference of the coils Is it po...

I ma looking for a training session will ECU master be able to help me..............

The first is always contact your local dealer im sure they able to help.. all dealers in network know products and more than happy to help.. obviously if you purchased your product from ebay or other source is bit different story Thankyou for the update there are currently no dealers in India and h...

Hi Im planning to use Bosch LSU 4.9 wideband sensor is it possible to have this option in the next software version ???

3ms is advised and u go higher u will end up frying you coil.....

Connect one injector ground to one injector output. Ignition switched, fused, 12v supply to injectors. Same as all other aftermarket ECUs. Thank you this was a little confusing me when i looked into the manual I later thought that injector output from EMU should be connected to ground and thank you...

Hi All,

Usually we have 2 pins in the fuel injectors
a.12v
b.gnd

the EMU manual is confusing me with the injectors pins which has to be connected on to EMU
all the other ECUs we connect the gnd pins to the standalones so a little confused with this configuration

Personally I would throw away the distributor & leads. Then fit individual coilpacks that have a built in amplifier (denso, bosch) & run them in wasted spark using just the crank trigger. Hi Mate thank you so much for the inputs i thought on these grounds as well but thot it would consume more time...

Hi All, I have EMU and want to use this on my swiftGTi turbo setup. As EMU is new to me trying to seek some help in wiring the EMU and to fire. I would request some inputs as this is a distributor and wanted to know how to make use of this for the cam input. how do i set the trigger pattern. is ther...

Hi, These are the swifts back in India which are from 2005 to 2013 these suzuki swifts are running the G13 platform they have coil packs cam and crank sensor. after analyzing the DET3 its confirmed that we need not connect any of the ignition coils and it has to be connected to the crank or the cam ...

hi barto will you please help me in the wiring of det3 on the suzukis

hi were you able to fix this det3 on your car if yes will you help me with the wiring

DET 3 Ignition Control for 2 Ignition modules in a Suzuki Hi All, I have an issue with the wiring connections on the IGNITION MODULES on a Suzuki which has a wasted spark type ignition system. Now I am little confused looking at the Ignition wiring on the DET3 side and also on the OEM ECU side. I wo...

Hi All, I have an issue with the wiring connections on the IGNITION MODULES on a Suzuki which has a wasted spark type ignition system. Now I am little confused looking at the Ignition wiring on the DET3 side and also on the OEM ECU side. I would like to know the below mentioned which will help me wi...