Ecumaster forum

Hi.

Could you implement PID regulator on parametic output? I would like to run a Pierburg cwa200 electric waterpump and set a specific coolant target. The pump is controlled with PWM signal 150Hz 12V

Thanks

Here is one of my trying looms

https://www.dropbox.com/s/qzlszyozk2bb0 ... 1.jpg?dl=0

The owner of the car is or was quite happy with the iq3. He had the wolf v500 ecu before switching to the emu, and the dash was great. Now, not so great when no working. The software is a bit confusing at first, but when you get to know it it's quite alright. Easy to change texts and scaling the val...

Hi all.. I am trying to connect a racepak IQ3 dash to the emu, without luck. The plan is to use the haltech e11v2 protocol via can-bus. so I have connected the can-bus module so it can imitate the haltec ecu. Then I have the racepak 230-VM-EFIHAL2 adapter to take the haltech can data and convert it ...

They best solution for the drag racer should be limiting slip by measuring it all the way from start to end. For example comparing the rate of acceleration on each gear or comparing front and rear axle. Depending what can be used. Yes, that could also be good. Then Again, that damn converter, it wo...

I am doing it with one setting. It makes for example 0,2BAR at 30%TPS, 1BAR at 50%TPS and 1,5BAR at 100%TPS at the same RPM. SO you can adjust amount of power at launch without changing the launch RPM ... this is how i do The problem is that the drag cars I have mapped is not with manual transmissi...

Hi... Is there a way to make variable launch control, or can it be implemented? It would be nice to have a function where an analog input could be scaled to final RPM activation/cut via a potentiometer. It would be a great feature for those who race the 1/4 mile on different tracks (big difference i...

HI all... I want to connect the EMU to the RacePak IQ3 dash, How can i do that?? Is it possible to use the serial output from the ecu, if yes, which V-NET adapter should I use??? I assume that the serial data in the dash is only for connection to the laptop programming software?? The Dash is that mo...