Ecumaster forum

Hello!
I have a problem with my update ..
from 37 to 39
My VE table is no longer correct after dm update.
(It runs too lean)
Has anything changed or How can it be.
Thank you!

Best regards
Peter

hello
have the problem found
turbo damage Oil in the intake

have the spark plugs removed, there are the four black

hy
have tried the new setting
the engine is operating normally at the booth when I go and give Starck gas he goes super
then below 2000 rpm it only runs on three cylinders
after some time again on all four cylinders

Have tried to verãndern but the engine Always runs the same My problem is that the lambda value is not going down when I go from the gas

Hello! My motor has a 3-pole sensor I have already switched to trigger 60/9 Perhaps you know the injector phase?

fotos

here I still have the connection diagram
and scope

Yes Bosch standart

the plugs is new
and how is it a setting that I that they stay cold

have it all changed still the 4 cylinder
Today I drove 20 min normal then it started again

Hello
have today Engine compression tested 12.9 bar all 4
cable from the ECU to kündmodul I also dipped
and also fat and lean gestelt
still the same problem

ignition module is new
Injector I have exchanged 3-4

It is always the fourth's. I have also tryed an other ignitionoutput on the ECU.

Hello
the engine is running so fat because he has been working on three cylinders

Hello
My engine runs normally when it is cold
when it is hot it is running on only three cylinders under 2,000 rpm
when I go over 2000rpm it is running normally

the ignition module and the spark plugs are new

Good day

ecu file

Hallo,

over OUTPUT/PWM#1 the idlespeed is 1000 RPM adjustable but not stabil. Now i want to go over IDLE. When i try it runs on 2000 RPM and it's not adjustable.
Please help me to find the correct adjustment.

hey
my scope does not know not how I set it
the motor has a hall sensor
will try the ignition map

thank you
Peter

I have the original Turbo with valve control.
Ignition map I have not yet been set.
Are you a base map for me?
Thank you Peter