Ecumaster forum

this one is what we used to use

are you useing map sensor ?? going buy the settings you are and the log is showing 100kpa all the time

the coil pack new ??? we use the ecotec coil pack and that does the same thing when its getting old and we run 3 bar of boost on one of these coil packs up to 8200 but the sensors are known for it after 6.5k hall sensors are better over vr ones but if its a new sensor and its wired correct then it s...

post your config file

as its going from lean to rich

Jan32 wrote:You and your team are amazing.
I love the ecumaster poducts.

ill second that but havent had much chance to play with mine due to work etc

but i do check every day for updates etc so i dont miss anything

keep up the good work guys

it crashes the software if you alter either tps % all the others are fine this is with out ecu conected

on windows 8.1

Looks good and I'd like to make use of this but I'm a bit of a retard when it comes to phones and tablets etc I have a Motorola with Android software and I see 10" tablets on Ebay for about £50 with Android Is it the same software for both phone and tablet ? Can data logging be done to the phone or...

its not a lot differnt to megasquirt :) been useing m/s for 10 years and switched to emu now i have basic settings some where ill dig them out for you what coil pack are you useing ? gen xe one or later ecotek one ? 10deg before tdc is tooth 9 or 114 deg injectors will be your fireing order or you c...

plain and simple you need air temp sensor ! even 1 deg differnce will alter your fueling thats how it works and its even worse on a turbo car

fit one and get it mapped again and you will see the difference straight away carry on the way it is it will end in dead engine

the let knock sensors are around 8 khz if thats any help

try inverted output

post your emu file

sound like you have no live after start

have you updated the firmware on the ecu ??

Thank you for sharing. This week we start new subforum with base maps for popular engines. about time :D would be nice to get some base maps and running maps on here it would save you a lot of msgs asking for them :) plus people can post there own up and before we no it we will have a good collecti...

here I still have the connection diagram and scope Hello peter Wenn ich mich nicht irre,hat der z20let motor vr kw sensor und nicht wie in deinen Primary trigger einstellungen zu sehen hall/optical sensor ,und der first trigger tooth sollte nr 9 sein,trigger angle dann 60 grad(prüfen mit lampe),bei...

so when its running its fine but when you put your foot down and then let off its goes pig rich then runs on 3 ? does it clear itself after a few mins if left alone ?

carnt look at log on phone

if its still the same on 4 with injectors changed etc just wire up injector 5 and try that in place of 4 and see what that does then that will rule out injector 4 completely

fire 2 banks of injectors at a time and see if that helps fire 1&4 and 2&3 and see what that does but its always number 4 thats getting the most fuel

i take it the setttings i sent you dont help ??

glad it sorted it out

is doesnt always show up thats its a bad sensor on the logs but 80% of the time at high rpm its usally the sensor at fault