Ecumaster forum

hi, my advise, keep original ecu and wirring loom. let tuner adjust software Delete all FAULT CODES. then put emu black in piggyback mode put injectors and coils and throttle body directly to ecumaster connect ecumaster to boost controll solenoid and split signal of temp and clt and AIT to emu as we...

hi,

no you need to end injection before opening intake valve....

so i gues most of my ecu's are between 450 and 300degree.

Hi,

just hook up 14Ohm resistors to original ecu 5Watt .

or reprogramm original ecu for DTC off ....

what bike is it ?

Hi, mitsubishi outlander turbo 4G63 205HP 2005 installed turbosmart wastegate actuator and software tuning, can't get my boost up.. EDIT car doesn't have map sensor and MAF really sucks to use with DET3. so we spend more time finding limiters and where able to get it set all limiters off for boost. ...

FIT mode is possible, test it today but problem is that i am not be able to use MAF/MAP conversion in FIT mode at the same time. Problem is we don't have extra analog in to use EGT solution(do to limited inputs or we should connect EGT to CLT imput and recalibrate should be a good option) positive i...

Hi all, I am running my 1999 audi a4 1.8t in FIT mode and is running fine, I want to increase the rev limit but unsure on what effect this will have on timing as I assume the ECu will not have a timing table past the factory rev limit? just dont want to blow anything up, Thanks you have a very old ...

Hi, what is the best way to control 2-4 additional injector on a throttle body sandwich plate ? if you convert a NA engine to a boosted engine, and the ecu is old-school or complicated or impossible to adjust. and you have automatic and ESP TCS adaptive cruise control etc etc So what we do, is insta...

for mac valve it is not necessary to ad flyback diode :D EMU will handle it without. Can a boost control solenoid on 20- 30Hz be driven by stepper motor output ? its a pierburg valve form VAG , or vauxhall. part number : 7.00470.07.0 they are crazy cheap like 25 -30 euro's FEP connector is like 3eu...

In car it is very complicated to use the mouse. It is better to use only keybord. So if you want to enter value to cells just select the cells (SHIFT + arrows like in excel) and just type the numers or press enter. If you want to make any math operation just write it. Eg 2* will multiply all cells ...

a nice feature would be able to select cells and then click richt mouse and choose enter value.... like most of the ecu's have and DET3 has..... maybe i misted something. but its not there on emu maybe open up tunerstudio Ms one time and have a look, much more plausibility's. to enter number, VE tab...

Hi, i am looking to manipulate KE jetronic with DET3. http://www.audinsane.se/bilder/ke-jet1.jpg like you can see here there is only 1 valid way to do this. disconnect the pressure actuator, and hook it up on the PWM out from DET 3. need to figure out original PWM and frequentie. adjusting timing is...