Ecumaster forum

Yes, it is a 6 pin.

The Throttle body might be from another engine code.
It looks like the 06A 133 062 BD body applies to several different engin codes.

Hello

I am fitting an EMU Black to a VW AGU engine, the throttle body is a 6 pin version, but i cant find a wiring diagram, can anyone help me?

the throttle body is of a Golf4 GTI, part number: 06A 133 062 BD.

Thanks in advance, Thomas

Thanks.

But it seems weird that the needle stays in the middle, while the light is on?
I will fix another Way ro read the temp, but i would really like to know if i do have a cooling problem.

Hello I have a can-bus module connected to my E46 instrument cluster, i works ok. it's a track car so the only functions i need is: Rev-counter, oilpressure warning og temp gauge. while racing this weekend, the temp gauge was very steady, right in the middle. But then the red temp gauge light went o...

Thanks, the version you link to is the 1.100 which is the one i have.
-i tried deleting the program and re-install, all the same.

But then i found a 1.32 version, and now i have the BT option!

i have connected my BT module.

but when i go to Ext. port - General - i dont get the "send data to BTCAN module" possibility....

what am i doing wrong?

well, i guess there is something gone wrong in the ECU..
But i would really like to know what caused this, -so it dont happen again.....

Have anyone tried this before, maybe there is an electronics-guru out there that can figure out what sort of component is faulty inside the ECU.

If i disconnect the grey connecter, There is ground on G15 -measured on the pin in the box.

There is no connection to ground in the wiring to the injector. (its a engine-only homemade harness, so everything is very easy to check).

thanks, i will try to post the map/log. I have done some more measuring. If i pull the connectors off the injectors, and measure the 6 injector outputs on the Emu, there is "full" ground on injector 2 (G15) -all the time, no matter if power to the box is on or off. Even with the gray connector compl...

Hello My Emu setup has always been working just fine. All of a sudden it drowns cylinder 2. after a bit of messing around it becomes clear that the injector 2 output is Switched to Ground constantly, therefore the injector is open all the time. The 5 other outputs are "pulsing", this is just a const...