Ecumaster forum

250KPA motorola MPX map sensor is build inside of the DET3, to terminal number 14 - analog#2 in. Analog 2 is set as a load by default. Please select motorola mpx4250 map sensor for analog #2 in setup Is there a reason why motorola mpx is only scaled between -0.8-1.5bar? instead of 2.5bar? Yes. 250k...

Kisielisodd wrote:250KPA motorola MPX map sensor is build inside of the DET3, to terminal number 14 - analog#2 in.

Analog 2 is set as a load by default.
Please select motorola mpx4250 map sensor for analog #2 in setup

Is there a reason why motorola mpx is only scaled between -0.8-1.5bar? instead of 2.5bar?

All good now guys! Figured it out by accident when I decided to reflash to previous firmware and noticed the analog gauges were displaying 0 voltage. Yay!

Ok, so I grounded all the analog outputs except for #2 and this is where they all sit at.

Is that supposed to happen?

Hi all, recently installed det3 with the internal 250kpa map sensor. I'm trying to use analog outputs to log AFR's from wideband controller which I wired to pin #4 along with tapping IAT/CLT or tps sensor (on the ECU side) in #1 and 3# pins (considering analog 2# is for the internal map sensor) The ...