Ecumaster forum

The file is attached here Nicky761.

But you can't use the ign table or fuel table when our engines are different. But some settings should do.

M20B25 block 86mm 3.123ccm M54B30 crank 89,6mm M54B30 rods 135mm JE pistons 86mm 12.5:1 Ported 885 head Schrick 288 NUKE camgear RHD itb’s RHD flywheel 3,7 Hartge manifold Ecu Master ECU Bosch 3x2 wasted spark E34 M5 3,6 injectors Adjustable Malpassi fuel pressure regulator https://farm5.staticflick...

Here's your answer, works like a charm on my engine.

https://www.ebay.com/itm/BMW-M20-M30-bi ... 3621795090

the folowing wil only make flames and minor bangs: - go to your fuel cut tab - make sure it wont cut fuel under deaccel - bump up either condition under which it wont cut the fuel (fuel cut underpressure/tps limit/rpm limit) - check the box with (dissable spark when overrun....) - make make the low...

Overrun fuel cut ... hmm i will better say decel fuel cut Set Fuel cut resume below RPM 6900RPM Fuel cut above RPM to 7000RPM This will not cut fuel under 7000RPM even on deceleration. But all the feul need also air to be able to burn. So if you TP is fully closed, you will probably have just very ...

Yes is it possible

Thanks a lot!

Hi Guys I'm looking for some extra pins, do any one know where to by them or the name of the? See pictures on this links. Front http://i62.photobucket.com/albums/h98/Schlander/M20B32/IMG_8429_zpsztuayqsh.jpg Side http://i62.photobucket.com/albums/h98/Schlander/M20B32/IMG_8430_zpsgzyycyuw.jpg Back ht...

I would love if the data for the newer LSU 4.9 where in the software so it was a PNP solution :D http://www.aemelectronics.com/products/gauges/wideband-uego-air-fuel-gauges/digital-wideband-uego-afr-gauge/digital-wideband-uego-afr-gauge http://aemelectronics.com/files/instructions/30-4110%20Digital%...

Possible. I have the same setup Innovate MTX-L and wired the analog out to one of the available analog ins of the EMU. Then you go to Oxygen sensor setup and set it there especially the voltage mappings, issue I only have is that I cannot put the exact voltage figures for minimum and maximum becaus...

Will the normal EMU ecu accept the LSU 4,9 directly?

Just a little helper..

Here's a picture of the trigger wheel and the sensor.