Ecumaster forum

Hi, I'm planning to install EMU to Civic 8th gen FD1 with R18 engine. It's turbocharged.
Any of you guys have ECU pin terminal diagram for this civic? Will EMU canbus will communicate with Civic CanBus? Thank you..

Jadzwin wrote:You can buy Microchip CAN BUS analyzer. It is quite chip and very helpfull

I bought canBus analyzer from microchip. Try to hook it up into canBus cable beneath steering above foot rest. But no luck. Any step by step guide doing this into bmw E46?

Curious about this one too. help..

what Windows are you using? have you be sure DET3 recognized in your Microsoft windows System Properties? Any COM Port conflict ? Be sure to crimp terminals in DET3 nice and tight, check on terminal 1 & 11 on your DET3 with volt meter to make sure you have good IG+ and ground (nominal battery voltag...

beware of ignition cable and spark plug used. make sure they have resistance to lower the noise from ignition system. Sometime you need to flash back in the firmware to fix it. Its my personal experience from other programmable ECU.

go to ecumaster.co.uk and download the software.

is it normal signal from "get data" and "load data" inverted?

Looks like a 12-2 24-2 to me.