Search found 3 matches
- Thu Mar 29, 2018 10:20 am
- Forum: PMU
- Topic: PMU CAN communication to ViPec i88
- Replies: 7
- Views: 4177
Re: PMU CAN communication to ViPec i88
Getting forward with this. Just to clarify. If I want to send TPS % info from Vipec to PMU (to start 2nd fuel pump as TPS over 20 %), I have now under parameters on ECU side in CAN-setting for transmitting TPS data/bits: "Start 2" and "Width 16" and divider 10 for TPS. Is Bit setting "Start" in ECU ...
- Wed Jan 03, 2018 2:59 pm
- Forum: PMU
- Topic: PMU CAN communication to ViPec i88
- Replies: 7
- Views: 4177
Re: PMU CAN communication to ViPec i88
Thanks for informative answer! ;) Just to clarify the ID number. For example, if I set ID as 500 in Vipec, PMU should have the ID as 0X500? And under "Frame1" in Vipec I can list all the parameters that will be send to PMU? Or is "Frame" parameter for example for engine FAN that PMU recognizes from ...
- Fri Dec 29, 2017 9:24 pm
- Forum: PMU
- Topic: PMU CAN communication to ViPec i88
- Replies: 7
- Views: 4177
PMU CAN communication to ViPec i88
Hi, Just purchased PMU 16 to my project car. My ECU is ViPec i88 / Link G4+ that has CAN Bus. I would like to know how to connect PMU and ECU through CAN and make power control via CAN. Done quite a lot ECU stuff but have avoided CAN communication basics with success.. :D There´s info how to make ba...