Ecumaster forum

Hi I'm looking for some advice and general comments about the idle. A few facts first: 3SGTE rev 3 in a GT FOUR New clutch still breaking in so a Dyno is not an option for another 500 miles or so Base map was from Scott at ATS and I've not tweaked any of the idle parameters from the original without...

There are dip switches inside the breakout box, I have the PDF. I also have a base map that I used from Scott at ATS and works great as a starting point. I'm on a Gen 3 3SGTE. The ECU connectors may be the same, just the pins may be a little different. http://rrrshop.co.uk/toyota-3sgte-adaptor-379-p...

Thanks for the advice everyone. I've had no problem connecting with the ecu, the problem is in the software for the dash. I was hoping someone had some experience with the race technology software. I've been chatting with the makers so hopefully it will be resolved soon.

I've had no issues, I prefer 7 but I'm using Windows 10 on a MacBook and no problems

Happy Christmas everyone, hope you all had fun

Has anyone any experience of using Race Technology Dash 2 Pro? It's all wired in, but there is no option in the pull down and the Wiki on site is not much use, I'm having a problem as there is very little information.

Thanks in advance

I've only just had my first test drive today I use AEM water/meth kit at 50/50 and only run 1 bar of boost so im not anticipating to much of an issue I've set the knock sensor up as per the manual, and in a few days I will start to test to see where the threshold of engine noise is. I also have 2 kn...

Thanks guys

It was there all the time

Hi I have a donut knock sensor from RR performance to fit to a 3SGTE. How do I connect to the ECU? Some donut sensors use the engine block as ground and join the two wires, I think subaru do. Obviously one goes to the ECU. Do I connect both wires together, use 5v reference on one wire and second wir...

It was you, same user name
think we should join forces
it's going to be a long journey
thanks for the PDFs that's a great help
shame they didn't come with the adaptor
I guess it's a new product and company so these things take time,
very good product though

pepifebles wrote:This is correct wiring and settings pnp adapter.

Thanks

Are you on GT4OC, I was posting on a guy from Tenerifes post about EMU today

Hi

Hope someone can help

When I wire the adapters am I right to go by numbers as in the top picture or a straight line as in the bottom

Thanks