Here you can see the scope Signal and the primary trigger Settings.
Search found 5 matches
- Sat Apr 16, 2016 3:56 pm
- Forum: EMU STANDALONE
- Topic: No trigger signal
- Replies: 7
- Views: 2423
Re: No trigger signal
Here you can see the scope Signal and the primary trigger Settings.
- Sat Apr 16, 2016 3:02 pm
- Forum: EMU STANDALONE
- Topic: No trigger signal
- Replies: 7
- Views: 2423
Re: No trigger signal
I tryed to see a scope with the HALL settings, thanks for your tip.
And I get a scope signal, picture will follow.
But now what is wrong with my VR settings, the Bosch sensor I describe above is definitely a VR Sensor?
Is there a failure with the electrical path inside the EMU?
And I get a scope signal, picture will follow.
But now what is wrong with my VR settings, the Bosch sensor I describe above is definitely a VR Sensor?
Is there a failure with the electrical path inside the EMU?
- Fri Apr 15, 2016 8:25 pm
- Forum: EMU STANDALONE
- Topic: No trigger signal
- Replies: 7
- Views: 2423
Re: No trigger signal
Thanks for your answers, yes the amplitude is 7V. I will try it with HALL settings, should I activate the pull-up? Thanks for the picture, but I realized the right connector numbering from backwards before. It was connected in the right way before I try to start the engine first time. I think the pi...
- Mon Apr 11, 2016 5:31 pm
- Forum: EMU STANDALONE
- Topic: No trigger signal
- Replies: 7
- Views: 2423
Re: No trigger signal
Yes, i did enable scope in primary trigger settings and push the "get scope data" Button while cranking.
- Sun Apr 10, 2016 8:16 pm
- Forum: EMU STANDALONE
- Topic: No trigger signal
- Replies: 7
- Views: 2423
No trigger signal
Hey guys, i have a Problem with my Setup. Yesterday i would start the engine first time after installation. First I have checked the signal on primary trigger and I don't have any scope. I use a 60-2 trigger wheel and a Bosch motorsport VR-sensor 0261210136. Here the things I've checked: - check usi...