Ecumaster forum

Hi guys ,
Would any one happen to have the calculations for the ecu masters low cost 10bar pressure sensors , iv opened it up and it's not a simple 0.4 - 4.5v you have to fill them all out and I can't find the info anywhere
Thanks in advance
Luke89

Hi guys have a friend with a mk5 Vauxhall astra vxr currently 630bhp but limited by factory ecu ! Is it possible to change over to emu with can control and keep all the factor wiring loom clocks abs traction control cruse control ect ?
If so how would we go about the coding?

Thanks
Luke89

Hi guys need some help , May sounds stupid but I'm stuck :lol: 12v live feed to the ecu , can I just take off the ignition switch add a fuse inline and run it straight from there ? There is no main fuse like a fuel injected car in my loom as it's from a 86 Ford Fiesta carb , Iv added a new fuse box ...

hi everyone , just trying to do a base map on my zetec with toyota coils , wired direct from the ecu . i have found the dwell times but need info on fire order and settings on the coil dwell wizard , single fire? amp ? i have mine wire on the coil pin1 12v + pin2 pin3 signal from ecu 1: g8 2: g16 3:...

Hi I was wondering if any one has a base map / start up map for a zetec turbo or could help with one ? It's got Yaris coil on plugs Id1000 injectors 8-5-1 compression Edit to say any zetec base map or igniton values or Yaris coil data will help ! I have the pin out for the ecu if it will help Many t...

Thanks Chris just seem to be stuck on the last few wires now
My alternator has 2 pins to the ecu .....
And engine run relay
Once I can work out where to wire them to I'm good to carry on

Hi all new here , just started to wire up my Ford Focus zetec turbo using the old loom just changing the plugs after looking at the diagrams I have 6 wires all to pin b18 is this ok to join to these together ?
Any help would be amazing
Many thanks
Luke89