Ecumaster forum

Show us scope when cranking

just install emu black windows client and you have there manual and wiring (pinout)

Maybe some other windows process is using this usb device ? So the emu app can't use it any more. Find in google how to check which process is using this usb device. Or simply after connect to the laptop go to device manager and turn off emu ftdi device and then turn it on back this will bring them ...

All grounds must be in star topology - more don't means better.

Hi, Can someone explain in details how definied CAN stream is working ? I can set ID, DLC. baudrate i supose is taken from interface configuration site. Now i can set type Rx or Tx. Rx is very small section. At TX data how can i choice correctly parameters ? Is too much and from where should i know ...

Use 10ohm resistor. Check how to connect yours
bt module with arduino (atmega328) and do the same.

With 50deg ignition timing what do you expect ?

Show us battery voltage logs when fan is spinning

Maybe ecumaster can develop multi pwm output stage controled via CAN ?

And what about 0 280 158 829 ? Is the same cng/lpg ? I know that both injectors peoples are using with meth/etanol/pb95 without issues.

VR sensor dont need +5V. Are you sure that u are using vr sensor ? Or it is hall sensor ?

Take a look to EMU Black booklet.pdf

Injectors up to 8 HiZ injectors

EMU Black is for high impedance injectors so you need resistor pack.

Change cranking treshold to lower value, and also why on the logs i see 65536 rpms ? Some problems with trigger or what ?
Next thing - check Your injector phase settings, current settings looks funy

Can You add PWM of haldex pump and also PWM of solenoid valve to the emu CAN stream ?. And also what with haldex oil temperature sensor ?

Waiting for first dyno and drive

Yes,when clutch oil is overheated (>100°C) clutch is disengaging rear axle.
Also max allowed torque depends from oil temp. I think inside oem controller are some tables in function of temp.

It is not possible to controll haldex steppet motor from emu. You can make own voltage->steper postion controller.

Sorry, my mistake. For VAG wheels speed data is at 4A0 You are also emulating stock ECU with black that the abs controll module dont shows "no communication" DTC ? I've maded such ECU emulator in the past.

For which ABS system ? I'm running ASR fwd mk60 and wheels speed information are in id 0x2a0. All old VAG abs/asr/esp are using the same ids 1A0, 2A0, 5A0, and some have also xA8. If i will build pwm to steper motor controler can i use this function with haldex1 ? For me better is too have all in EC...