Ecumaster forum

Hi now have diesel cdti 1.9 signum I can do full remap but cost a lot there do i live and have det3 Firstly though ll buy tuning box to trick fuel pressure sensor to increase fuel pressure but still expencive for simple resistors Now idea with det3 to do that but in piggyback mode Now question how i...

Hi previously wired up in piggy mode everything was fine
Now wanted to wire to fit mode wont start injectors not getting fuel.
Made all settings as described .
Aswell if i want to enter clt and iat rx values then showing same value on clt or iat ...
Help me

No probs at all.launch control rev limiter etc everything works.
Aswell didnt used shielded wire but runs fine.

Hi i have bug sport so is almost the same as your gc8 .
I tryed vss input to fraquancy in but didnt had any luck .doesnt work.
Ll be nice to know it..

Mine 03 na subie didnt worked with subaru crank trigger.
Had to use retard single signal.and had to change num per rev 7
to make it correct.by this way i can only retard ignition.thats for u need.good luck.

Thats in piggyback mode .
If fit mode i ll need to make adjustments manualy for every cell.
So then driving alone isnt funny to do that.
Would like to have auto tune feature just low mid rpm ll be handy

Hi i know u stopped updating software but ll be nice to have autotune feature it ll save loads of time etc.
I would like to know your tips of tuning on the road if u are alone

PAGE 21 try to read this : Tables switch input DET 3 device has Tables Switch Input (Pin 2), which is primarily used to switch the table set (it allows the user to prepare two sets of tables depending for example from the type of fuel used). In the Fuel Implant mode it is possible to use this input ...

Hi would be nice to have afr target table and autotune as we can use wb input so isnt hard to do that will be more easer to tune,easer to use more customers.

bondango wrote:ignition mode:subaru
input type : VR sensor adpative threshhold


crank sensor - 2K resistor - ignition in
bi polar ignition out - Ecu

hi thank u for tip
tryed 2k resistor to ground as shown on the wirring diagram

u mean 2k inline vr sensor?
vr-2k-ecu

http://www.ecumaster.co.uk/pobierz/det3 ... agrams.pdf

page 24
configuration 7
should work.Folow that wirring and settings.

Cant get ignition working, Det3 shows rpm but wont sync . Shows Syncing-syncronized-no sync and repeats again Pin 9 to b135-1>>>>>vr sensor --------------------------Pin 5 bipolar to b135-1 ecu side. ignition options: 6wheel subaru trigger couldnt start my car scope shows nothing so changed over Pin...