Ecumaster forum

2005 Audi A4 B6 Quattro 1.8T ecumaster ecu + 1.8t adapter + canbus + bluetooth CP Pistons IE Tuscan Rods arp head studs arp main studs AEB Cylinder Head acl race rod & main bearings Dbilas springs retainers Supertech Inconel Valves 75mm golf r32 dbw throttle body clutchmasters 725 twin plate clutch ...

hello
Does anyone have a basemap for Fiat 5-Cylinder engines ?
Bravo HGT
or
Stilo Abarth 2.4
or
Fiat Coupe 20v

thanks..

p.s. : whatever I tried on the cam wheel - it didnt work properly..

hello. does anyone have a m52 basemap ?
i need the trigger settings and my customer have no ignition gun. engine sensors are stock.
thanks

although i dont use ego feedback ?

of course from emu to emu black

it is imported %100 correct.
tested.

I imported a e.mu file and the car doesnt start EVEN all the necessary settings (fuel settings, tables, ignition settings, enrichment settings) are COMPLETELY imported fine. the only problem with this is fuel is not enough. when I increase the fuel by around %30 - the car runs fine. but the upper pa...

yes there is

if u get the power from a relay directly connected to the battery, your voltage readings will be perfect.

no answers ?

is it possible to make the Brz work with det3 ? the engine is superchaeged.

we've found a cam timing error.
after re-adjustment - I'll tell you the result.

already tried that. doesnt help.

what do u mean buy soft or hard ?

check time 8:10 in the log.

here is the file & log

engine is fully loaded ford cosworth
car doesn't rev past 8000-8200 rpm

no limiters
no fuel cut
no launch control
afr at full throttle is between 12:1 - 13:1
ignition advance is around 28 degrees
no misfires.
no trigger errors.

what can be the problem ?
any comments ?

alright,
let's think of there are 2 same engines.

first one - max degrees is 50
the other is 40

if we give 35 degrees for both engines,
do they behave %100 same ? or is it scaled ?

(the strobe light degrees is equal to the engine at idle on both engines)

actually the question is :

as long as you make the ignition same as Emu with a strobe light,
does it matter what settings is it ?

when I give 15 degrees from EMU and see the 15 degrees with the strobe light,
does it matter what the max ignition angle is or any other settings ?