Ecumaster forum

thanks for your help again, i did just as you said and it worked for both my sensors.

hey guys i need help wiring my temp sensor. it is a simple bosch ntc 2 wire sensor exactly like the coolan one but when i wire it like the coolant sensor i get no reading. i was looking at the ecumaster help and it says to make a pull up resistor. how do i do this and what resistor should it be? i a...

thanks but it is sorted now, i had faulty coils. swapped to a new set and no problem. have had the car running a few hours with minor issues the lambda occasionally goes to 1.98 and stays there for about 30 seconds than starts working again i dont know how to wire in the oil temp sensor or the fuel ...

solved the sync error all it was is a bad crimp.
but still cant get the timing right.
i tried swapping over my trigger wires around and still no luck.

i did all the wiring my self.

so i should change my first trigger tooth from 3 to 2?

yes i did lock it at 0 and i had to adjust to 88 deg to align to 0. but i also noticed that the mark is moving. i have a sync problem also. if i can send you a log you might understand me better

i got the light to work. all i had to do is not close the clip over the wire and leave it open. i then altered the ignition to match actual ignition which i had to move the trigger angle to 88. but for some reason which i cant seem to solve i randomly loose sync for an instance. the file for the log...

hi i have started my 2jzgte and am trying to adjust the static timing. i put a hi tension cable between my coil and plug and connected the timing light but am not getting the flash. i tried the timing light on another car and it works. i then took 1 hi tension from this car and plugged it into the 2...

i am located in malta but today i was given help and sorted it out.

i have the same problem. tried installing the new version and still no difference. any help would be appreciated as i am trying to start up my newly built engine for the first time

thanks

so i would be better off using a racepak?

does anybody know if i can connect a tablet to the ecu via cable? (this tablet will be permanently installed in the car and will be the only gauges in the car)
if so could you possibly guide me through it?

any help would be greatly appreciated

Thank you for your help.

Which is the best way to connect all the wires together into 1 wire?

hi i have a question about how is the best way to group my sensor grounds to pin B18 i have the following grounds to connect all in the same pin and cant figure out the best way to do it: cam, crank, egt x2 , fuel pres, oil pres, flex fuel, air temp, clt, tps should i just connect the crank and cam ...

i purchased a flying lead harness and the cam and crank sensor wires included are not shielded. should i purchase shielded wire or use the ones provided?
on other installs that i have done ive always been supplied with shielded wires this is my concern

thanks

what cdi unit did you use? and does any body know where i can purchase new connector pins from. as the connectors i bought new from toyota come without connectors and the connectors they have are all already crimped to wires and i dont want to solder any wires.

thanks in advance

ok thank you for your help

and i dont need a hks dli? the ecu will do its job? as this is a 1000hp build?

thanks

hi, i am new to using an ecu master and am currently planning my wiring loom. jza80 supra 2jzgte i had a question about my coil packs. from what i understand i can run them with or without using the igniter, i was also going to wire in a hks amplifiier. what do you guys think is the best route for m...