Ecumaster forum

Genk, bij Hasselt. Jij ?

PBU wrote:Knap werk voor een 21 jarige.

Patrick

Bedankt Patrick ! Almost ready to fire it up !

Found a 60-2 trigger wheel


Keep you guys up to date !

Ok. this is very new to me...but if it work that way, I don't care ;) first: I see a difficult, because 360 degrees cannot be evenly divided by 137 teeth. second: The second trigger accures on EVERY single crankshaft rotation. so neither you, nor EMU can be sure where is TDC of cylinder 1....am I r...

Could it be possible the one on your picture is one from a type 1 ? Because mine is a type 2 When I was taking apart the wiring of the engine, the wires of the sensor in the front led to a death end at the diagnostic connector. I think it is only used for diagnostic purposes (to get RPM). So I am co...

The crown could have 128 teeth. But the question is WHY do you have to use it? Usually the M20 uses the sensor near the crankshaft pulley. As shown in parts catalog http://de.bmwfans.info/parts-catalog/E30-2-doors/Europe/325i-M20/L-M/jan1989/browse/engine/timing_cover_upper/ So I removed the gearbo...

pretty sure about it but I will remove the gearbox during the week so I can have a clear view.

thanks in advance

Hans

Hi guys ! My name is Hans, 21 years old and I am from Belgium. For my project I am using a ECU Master module to turbo a m20b25 out of a e30. The engine is totally rebuild and is already placed on a homemade test bench. The ECU is wired to the engine and I can crank it without getting started. So far...