Page 1 of 1
Zapłon Suzuki G13bb
Posted: Mon May 09, 2016 3:39 pm
by onyx
Witam,
Mam prośbę aporopos dopisania patternu do sygnału z wałka rozrządu dla silnika Suzuki G13BB na COP'ach, wykorzystywany również w 2.0 z Vitary
Może te informacje, które znalazłem pomogą:
http://www.msextra.com/doc/ms2extra/MS2 ... #mtsetting
Re: Zapłon Suzuki G13bb
Posted: Fri Jun 17, 2016 10:23 pm
by qpmz
Witam,
dołączam się do pytania. Zaznaczam, że g13bb ma tylko czujnik położenia wałka rozrządu.
Były też z położnikiem wału + wałka rozrządu, ale to egzotyka. Wtedy można je odpalić na subaru 30-2-2-2
@onyx czym dmuchasz do tego 1.3?
Re: Zapłon Suzuki G13bb
Posted: Sat Jun 18, 2016 12:55 am
by onyx
Odzew ze strony możnych jak na razie żaden... i chyba pozostanie w głębokim poważaniu.
Mam zamiar wrzucić M45, ale kwestia braku możliwości strojenia utrzymuje stan stagnacji...
Re: Zapłon Suzuki G13bb
Posted: Sat Jun 18, 2016 3:16 pm
by putani
DET 3 Ignition Control for 2 Ignition modules in a Suzuki
Hi All,
I have an issue with the wiring connections on the IGNITION MODULES on a Suzuki which has a wasted spark type ignition system.
Now I am little confused looking at the Ignition wiring on the DET3 side and also on the OEM ECU side.
I would like to know the below mentioned which will help me wire up the DET3 and solve the wiring issues
1. IGNITION IN - do i have to connect wire directly tapping the sensor signal voltage???
2.IGNITION OUT - there are three output pins which one should i coneect the IGN OUT wires from DET to the ECU
I request somebody would really answer my issues and help me rig up the DET3 on my car
Re: Zapłon Suzuki G13bb
Posted: Sun Jun 19, 2016 12:32 am
by onyx
Since now there is no trigger in DET3, that would work with cam sensor.
Probably subaru type of ignition trigger would work with crank signal and crank wheel from Baleno/Wagon r+.
Re: Zapłon Suzuki G13bb
Posted: Sat Jul 23, 2016 11:22 pm
by putani
onyx wrote:Since now there is no trigger in DET3, that would work with cam sensor.
Probably subaru type of ignition trigger would work with crank signal and crank wheel from Baleno/Wagon r+.
This version is without Dizzy and it comes with CAM and CRANK sensor
below image is the reference of the coils
Is it possible to advance and retard timing using DET3....
Re: Zapłon Suzuki G13bb
Posted: Sun Jul 31, 2016 12:24 pm
by onyx
As I mention above, there is no version of propper ignition trigger that will works with that engine (for sure if signal is taken from camshaft sensor).
The crankshaft trigger in Suzuki looks the same as Subaru 36-2-2-2 and if I look into manual right, it's not supported.
It would be realy nice if Jadzwin put firmware update with trigger of camshaft - some of Suzuki owners are waiting for this