hi
im intaling an EMU and building a new wiring loom on this engine
its a 2JZ-Gt
for now i have some questions...
on the cam, have 2 vr sensors for cam position, wath is the sensor that i need to use? the sensor on the middle of the head, or the sensor on the back of the head?
what is the configurations for the pimary and secondary trigger?
someone have a start up file?
and finaly
is the stock knock sensors compatible with the EMU.
if not
what sensor can i use?
regards
Toyota supra 2jz-gt non vti trigger and knock
Re: Toyota supra 2jz-gt non vti trigger and knock
I used cam sensor on the back of the head.
Re: Toyota supra 2jz-gt non vti trigger and knock
ok thankstonas wrote:I used cam sensor on the back of the head.
it is possible to send just a picture of the primary and secondary trigger setup?
-
Kisielisodd
- ECUMASTER TEAM
- Posts:227
- Joined:Fri Aug 15, 2014 9:49 pm
Re: Toyota supra 2jz-gt non vti trigger and knock
It doesn't matter which sensor on head You will use. EMU use only one for synchronization. Personally i'm using G1 in the middle on the head.
Re: Toyota supra 2jz-gt non vti trigger and knock
now im confused...Kisielisodd wrote:It doesn't matter which sensor on head You will use. EMU use only one for synchronization. Personally i'm using G1 in the middle on the head.
Re: Toyota supra 2jz-gt non vti trigger and knock
what is the firing order of that? can you post some screen shots?Kisielisodd wrote:It doesn't matter which sensor on head You will use. EMU use only one for synchronization. Personally i'm using G1 in the middle on the head.