how to connect the triggers to the audi 5 cyl(3B,AAN)??

gesch · Post by **gesch** » Sat Jul 09, 2016 11:07 am

CRANK SENSOR (135 teeth ) need to be connected to primary trigger
CRANK SENSOR (1 tooth) - need to be connected to CAM #1 (with 1K5 pulldown )
CAM SENSOR HALL - need to be connected to CAM #2

with 1K5 pulldown,where to solder??

Karel · Post by **Karel** » Sun Jul 10, 2016 9:15 am

On 5 cilinder you must know the TDC on working cycle for the 1st cilinder if you will use individual coils. (It wil be used as secondary trigger so CAM 1)

1k5 ?

pulldown always means connecting between sensor signal and sensor ground to lower the voltage, and noise also.

gesch · Post by **gesch** » Mon Jul 11, 2016 11:37 am

Karel wrote:On 5 cilinder you must know the TDC on working cycle for the 1st cilinder if you will use individual coils. (It wil be used as secondary trigger so CAM 1)

1k5 ?

pulldown always means connecting between sensor signal and sensor ground to lower the voltage, and noise also.

thank you

gesch · Post by **gesch** » Mon Jul 11, 2016 11:37 am

Karel wrote:On 5 cilinder you must know the TDC on working cycle for the 1st cilinder if you will use individual coils. (It wil be used as secondary trigger so CAM 1)

1k5 ?

pulldown always means connecting between sensor signal and sensor ground to lower the voltage, and noise also.

thank you

Ecumaster forum

how to connect the triggers to the audi 5 cyl(3B,AAN)??

Re: how to connect the triggers to the audi 5 cyl(3B,AAN)??

Re: how to connect the triggers to the audi 5 cyl(3B,AAN)??

Re: how to connect the triggers to the audi 5 cyl(3B,AAN)??