7mgte help

All about our superior engine management unit.
Locked
ihiryu
Posts:237
Joined:Thu Sep 17, 2015 12:10 am
7mgte help

Post by ihiryu » Fri Jul 15, 2016 9:11 pm

Hey guys,

I got a 7mgte that I'm working on. I purchased the PNP adapter and got the base map from WHP. The car doesn't want to sync whatsoever. It'll just crank and crank. If I disable cam sync, I can get it fired up.

Should I just leave it disabled??
Attachments
7MGTE_Startup_Final_440cc.emu
(99.69KiB)Downloaded 57 times

RHD
Posts:537
Joined:Tue Oct 07, 2014 4:28 pm

Re: 7mgte help

Post by RHD » Sun Jul 17, 2016 4:12 am

Learn to use the SCOPE function this will help you find the cam signal. Sounds like you have a problem with the secondary trigger, maybe sensor or wiring

ihiryu
Posts:237
Joined:Thu Sep 17, 2015 12:10 am

Re: 7mgte help

Post by ihiryu » Tue Jul 26, 2016 11:45 pm

Just an update, checked the air gap, and it was off a little. Did all three pads, according to the FSM, and now I have no sync whatsoever. I took a scope, and nothing shows.

RHD
Posts:537
Joined:Tue Oct 07, 2014 4:28 pm

Re: 7mgte help

Post by RHD » Sat Jul 30, 2016 10:19 am

if the sensor is producing a signal then the scope will pick it up. If there is no signal on the scope then the wiring or the actual sensor itself has a problem

Locked