Have a freshly built car sporting a 1.5JZ engine with a new EMU install. EMU has been excellent for the most part, almost runs like a factory car, but we do have one small issue.
We want to use a the boost by gear feature to control boost levels on the fly. To do this, I am going to use a 5K POT wired to Aux In #4 with a pullup to 5v, and setup the EMU to use this input as the gear selection input sensor, and configure the table as appropriate. Then we can use boost gears scale to reduce the DC by a fixed percentage across the sweep of the POT (through all gears).
The issue we have seems to be a bug in the firmware - I have not tried any other firmwares yet. As soon as we change "Gear Detection Type" from "Calculated" to "Gearbox Sensor", the EMU stops reading speed input! If we leave it set to "Calculated", speed reading works perfectly. The issue here is we need speed input as to be functional for things like launch control.
Anyone have any idea whats going on?
See these images:
Thanks,
Hayden
