launch control

fred64480 · Post by **fred64480** » Sat Nov 19, 2016 10:38 am

hello , How to connect launch control ??

PSI-Motor · Post by **PSI-Motor** » Sat Nov 19, 2016 5:37 pm

fred64480 wrote:hello , How to connect launch control ??

Read help files in the software or look in the manual.

fred64480 · Post by **fred64480** » Sat Nov 19, 2016 8:15 pm

Sorry but I can not find

PSI-Motor · Post by **PSI-Motor** » Sat Nov 19, 2016 8:34 pm

5v to a button, from button to a analog input.
If you go to launchcontrol in the software and press F1 you will get a pop up help

fred64480 · Post by **fred64480** » Sat Nov 19, 2016 11:08 pm

ok thank you , Sorry for English because I am French

fred64480 · Post by **fred64480** » Sat Nov 19, 2016 11:12 pm

Well, I found everything thanks to you but I can not connect to analog # 2 because dbw analog # 1 and # 4

nickbmw · Post by **nickbmw** » Sun Nov 20, 2016 12:40 am

Or just set it to always on and set the conditions.

PSI-Motor · Post by **PSI-Motor** » Sun Nov 20, 2016 1:18 am

Or cam input 2

fred64480 · Post by **fred64480** » Sun Nov 20, 2016 9:09 am

So to validate my editing it is output 5volt has my button and back on an analog output and I put a resistance of 2k2 to ground or no need. I can not put in cam # 2 because I have two camshaft sensors. Engine golf r32

Ecumaster forum

launch control

Re: launch control

Re: launch control

Re: launch control

Re: launch control

Re: launch control

Re: launch control

Re: launch control

Re: launch control