how do I configure the injection angle?that's right, I built the table?
audi 90 motor 3b 2.2 875cc gt3584
Injection angle how to set up?
- Attachments
-
ECU
Re: Injection angle how to set up?
In my experience not very important in most cases with port injection.
Just set it flat 360deg for begin. If want, fine tune low load/low rpm range when most of the tuning sorted.
Just set it flat 360deg for begin. If want, fine tune low load/low rpm range when most of the tuning sorted.
www.esracing.ee / www.facebook.com/esracingestonia
Re: Injection angle how to set up?
characteristics of the camshaft
The strategy of injection timing:
End of injection ???
Start of injection ???
at the beginning or the end??
The strategy of injection timing:
End of injection ???
Start of injection ???
at the beginning or the end??
- Attachments
-
ECU
Re: Injection angle how to set up?
It does not matter if you set start or end of injection.
Cam profile is not going to help, you have to tune it for best efficiency.
But as i said before, in my opinion and experience, it is not very important with port injection in most cases.
Cam profile is not going to help, you have to tune it for best efficiency.
But as i said before, in my opinion and experience, it is not very important with port injection in most cases.
www.esracing.ee / www.facebook.com/esracingestonia
Re: Injection angle how to set up?
Thank you!samvel wrote:It does not matter if you set start or end of injection.
Cam profile is not going to help, you have to tune it for best efficiency.
But as i said before, in my opinion and experience, it is not very important with port injection in most cases.
ECU