All about our superior engine management unit.
-
shadowlandz - Posts:20
- Joined:Wed Jun 10, 2015 12:41 am
Tacho rev counter
Post
by shadowlandz » Thu Jun 25, 2015 6:42 pm
Hi,
I want to fit a new rev counter (tacho), the wiring is that i need to give green cable to the signal of the RPM.
Does anybody knows what signal of RPM i need to wire on the EMU? (wire for RPM output)
Can i just use analoge input maybe..?
Thank you very much!!
-
PSI-Motor - Posts:455
- Joined:Fri Aug 15, 2014 10:57 pm
Post
by PSI-Motor » Thu Jun 25, 2015 8:38 pm
shadowlandz wrote:Hi,
I want to fit a new rev counter (tacho), the wiring is that i need to give green cable to the signal of the RPM.
Does anybody knows what signal of RPM i need to wire on the EMU? (wire for RPM output)
Can i just use analoge input maybe..?
Thank you very much!!
Use any aux and configure it under outputs. Standard is aux 4.
EcuMaster Sweden