1Jz soarer

[ZhT]

Ignition doesn't match when cranking. Ignition crank is 10 but with lamp that doesn't match.
Is that scope right? And why knock sensing give knocking every ignition event when crank?

[PSI-Motor]

Go i in under ignition output and try using ignition offset.

[ZhT]

Now is ignition ok but injector phase is problem i think. I have batch injectors. 1jzgte nonvvti, stock coils, 440cc injectors.
#10 injectors 1,4 and emu 1,2.
#20 injectors 3,5 and emu 3,4.
#30 injectors 2,6 and emu 5,6.
What is injector phases?

[ZhT]

Ignition base is 10 when cranking. But it won't start. Stock coils and igniter. Injectors are now in sequential mode wired EMU inj.1 car inj.1, EMU inj.2 car inj.2 etc..
Can anyone look my maps and scope signal?

[flubyux2]

i had to change my injectors to batch fire to get it to start. this only applies to the cranking condition.

[RHD]

if it only runs in wast spark but not sequential then use ignition offset 3 or start your ignition sequence from cylinder 6... ie 624153

[ZhT]

Now it runs. Ignition 153624 and injector phase 153624.

[tommyboyblitz]

Hi, sorry to jump in with a different question but I'm just after the iacv settings, does your one work with the settings in your map?

Cheers