Keelog serial connection

[chris72]

Hi
i now have Keelog 2GB time keeper, can you provide a connection diagram so i can make a lead, also i use bluetooth dongle for my dashboard i assume i can use both with the signals to the bluuetooth passing through the keelog device

thanks

[Jadzwin]

Please find attached EMU to Keelog manual here:

https://dl.dropboxusercontent.com/u/286 ... keeper.pdf

[chris72]

Many thanks
Excellent support as usual

[chris72]

Hi
is it possible to run Keelog device together with Blutooth module ?

thanks

[Jadzwin]

Yes. You just need to connect Keelog RX to EMU extension port TX.
It use the same baud rate as BT module.

[Jan32]

Hey i have now an keelog serial ghost logger but i cant import the logfiles in EMU client. Attached you find one logfile and configfile.
The Ascii code in the Logfile looks ok for me.

The import over Android log works with these log file, but the other import over keelog import function doesen´t work, maybe there is a problem in client?

[DT-GT42]

Where i can buy these parts?

Greetz

[Jadzwin]

Yor log looks a little strange. There is no time stamp inside. Are you sure you have Timekeeper device ?

In our logs there is a timestamp in the file that looks like this:

[2015/6/7 4:15:00] [1] asdadad

EMU client is looking for timestamps to find different "logs"

Hey i have now an keelog serial ghost logger but i cant import the logfiles in EMU client. Attached you find one logfile and configfile.
The Ascii code in the Logfile looks ok for me.

The import over Android log works with these log file, but the other import over keelog import function doesen´t work, maybe there is a problem in client?

[Jan32]

Hey Kuba,

The option Timestamp is active.

[Jadzwin]

We use the same...

Is power from your keelog dissapear when you turn ignition off ?
The timestamp seems to be written when the device is power on

[chris72]

Where i can buy these parts?

Greetz

Hi
I purchased mine direct from Keelog site and made my own lead but i think they are available from ECUmaster with lead

[2wheels1man]

Hi. I'm having the same problem as Jan32. Was this resolved?
I've edited the config file as instructed in your SerialGhost user's manual. Timestamping is on, but there are no timestamps in log.txt.
I can import it with the Android import option.
EDIT: I've tried using the official setup utility, but no change.

[2wheels1man]

I've also noticed, that when I import the log with the android option, LAMBDA value is always 0.00.
AFR has correct values though...
Maybe a bug in the software. ver 1.162

[Jadzwin]

For time stamping the problem is with the new version of keelog You need to write to keelog manufactrer.
According Lambda I will check it.

[shrek69]

For time stamping the problem is with the new version of keelog You need to write to keelog manufactrer.
According Lambda I will check it.

Any other Options to log data without pc connected.

[Jan32]

For time stamping the problem is with the new version of keelog You need to write to keelog manufactrer.
According Lambda I will check it.

Hey Jakob,

i fixed the problem with keelog but Lambda value isnt there.

[2wheels1man]

For time stamping the problem is with the new version of keelog You need to write to keelog manufactrer.
According Lambda I will check it.

Hey Jakob,

i fixed the problem with keelog but Lambda value isnt there.

+1

[Jan32]

Did you take care of this issue and also is the VE value nor available in the Ghost logger.

I think it is an Problem of the import function because the BT module uses the same protocol and there workes lambda an VE etc.

Please can you have a look about this issue?