Ecumaster forum

Hi, i am building a Ford Sierra with 2.0 ohc pinto engine and i got a map for my ecu master emu from Skogenracing.com that should work great for my setup as a start.
But the trigger is setup for 36-1 tooth wheel. I have not build any ignition system on it yet but have bouth VR and HALL distributor laying.
Can i drive with the HALL distributor ignition without external amplifier and crankwheel and most important what will be the settings for this.
I have attached an image with the setup for VR 36-1.

Johnny

Tryed to search the forum and came up with this, would this be the correct settings for startup?

you will need to wire the dizzy to the primary trigger input, you dont have a secondary trigger so disable it (unless the dizzy has a second single tooth pickup inside)

number of teeth including missing will be 2 since the dizzy turns at half crank speed

enable scope so you can see if your getting signals

next edge rejection 0 until you know its all working

i think that should work, but you really would be better rigging up some sort of direct crank sensor then modify the dizzy to give only 1 pulse per revolution and use that for the secondary trigger, injector sequencing etc.