Ecumaster forum

hi
does the Emu, normal or black suport the mazda rx7 engine trigguer?

is this case is to install into a rx7 2 rotor engine with 4 coils and 4 injectors.

regards

as far as i know its coming soon for the black

As far as i know ....... i made already the first Mazda RX with Wankel on EMU BLACK

Karel wrote:As far as i know ....... i made already the first Mazda RX with Wankel on EMU BLACK

ok

but with the regular Emu is impossible, correct?

It is, BLACK is basicly the same as the Standart EMU, just you dont need to add DBW module, or CAN module..... so the Mazda i made was the RX8 with turbo engine from RX7 (13B). So we needed Can for dash, ABS etc.. .and DBW for the RX8 pedal and Throttle body we used.

If you dont need DBW and Can for Dash you can use simple EMU.

Karel wrote:It is, BLACK is basicly the same as the Standart EMU, just you dont need to add DBW module, or CAN module..... so the Mazda i made was the RX8 with turbo engine from RX7 (13B). So we needed Can for dash, ABS etc.. .and DBW for the RX8 pedal and Throttle body we used.

If you dont need DBW and Can for Dash you can use simple EMU.

ok ok

As far as i know ....... I have been waiting for three years for EMU that support wankel engine. 20b changed to BMW n53b30 and I'm looking forward a two years on direct port injection.

adam_r wrote:As far as i know ....... I have been waiting for three years for EMU that support wankel engine. 20b changed to BMW n53b30 and I'm looking forward a two years on direct port injection.

Its all about knowledge, and never give up ......