Page 1 of 1
bmw m20 no sync
Posted: Sat Mar 04, 2017 5:35 pm
by bmwalex
hello i have wired up the emu and it connects to the ecu, but it wont sync, says no sync. using 60-2 trigger, any ideas? still running distributor but with and MSD ignition amplifier. but it wont sync at all. i have no clue whats wrong. not using the original "camsync" from the plugwires
Re: bmw m20 no sync
Posted: Sat Mar 04, 2017 6:38 pm
by PSI-Motor
Check your scope
Re: bmw m20 no sync
Posted: Sat Mar 04, 2017 7:08 pm
by bmwalex
When i try to scope it shows nothing at all. No readings
Re: bmw m20 no sync
Posted: Sat Mar 04, 2017 10:03 pm
by PSI-Motor
Activate scope under primary trigger, press arrow on the scope page that says "get scope data" if it doesn't show anything you messed up your wiring.
Re: bmw m20 no sync
Posted: Wed Mar 15, 2017 11:00 am
by bmwalex
Even tried with a brand new hallsensor, still no scope, its only pin 7 + 18 and 5v it want? How can it not work
Re: bmw m20 no sync
Posted: Wed Mar 15, 2017 1:20 pm
by bmwalex
Problem solved. Engine starts now!