Ecumaster forum

Hi,
I really need some help figuring this out..

I got my ECU Master classic wired up to my SR20DET in a 200SX S14. Made the wiring myself.

All stock coils are wired the same way without the stock ignitor. Only coil nr 4 will give spark. And yes i have tested several coils aswell, ign output 1,2,3 does not work.


Measuring at connector nr 4 i get +12V between + and -. And 0V between + and EMU output pulsing to +12V when using output test. Coil are working perfect here at this connector / output.

Measuring at connector 1,2 or 3 i get +12V between + and -. And 12V constantly between + and emu output.. Pulsing from +12V to +5V when using output test... this is very strange to me. And yes i have checked wiring.
I measure aprox 34k Ohms between output 1,2,3 and power ground on emu pins. And infinity between output 4 and power ground..


All help is much apprichiated.


Br,
Martin

ditch the igniter and run the coils directly from the EMU. make sure to select the correct settings for coils without amplifier

RHD wrote:ditch the igniter and run the coils directly from the EMU. make sure to select the correct settings for coils without amplifier

I have. Wired without ignitor.

sorry i messed that!

post up a cranking log and tune no one can help without those