Page 1 of 1
VW primary trigger
Posted: Sun Nov 26, 2017 10:21 pm
by gorinycius
Hi for everyone,how right setup this one primary trigger
Re: VW primary trigger
Posted: Tue Nov 28, 2017 8:04 am
by Jan32
it is an normal 60-2 Trigger with Hall sensor.
Angle depends how it is installed on the crankshaft. Is the engine at the picture in OT?
Re: VW primary trigger
Posted: Tue Nov 28, 2017 6:16 pm
by gorinycius
Yes,Jan32,is on TDC.Can you write my right setup for primary trigger?(sensor i mark in white)
Re: VW primary trigger
Posted: Tue Nov 28, 2017 6:51 pm
by PSI-Motor
Use timing light!
Re: VW primary trigger
Posted: Thu Nov 30, 2017 10:30 am
by Jan32
It should be this setting:
first trigger tooth maybe +1 or -1 means 5 or 3. Please check the ignition angle with timing light to be sure.
Re: VW primary trigger
Posted: Thu Nov 30, 2017 5:21 pm
by gorinycius
Thanks for replay,Jan32.This weekend try start my project
Re: VW primary trigger
Posted: Thu Nov 30, 2017 7:11 pm
by Paulo11
Jan32 wrote: ↑Thu Nov 30, 2017 10:30 am
It should be this setting:
first trigger tooth maybe +1 or -1 means 5 or 3. Please check the ignition angle with timing light to be sure.Trigger.PNG
I think this isn´t good setting, because teeth are counted from opposite side.
So, the correct setting for me is: First trigger tooth- 33(+-1), rest is good.
Or am I wrong ?
Re: VW primary trigger
Posted: Fri Dec 01, 2017 12:00 pm
by Jan32
Paulo, sorry you are wrong
Trigger wheel is located at clutch side and goes ccw direction!
Re: VW primary trigger
Posted: Fri Dec 01, 2017 7:26 pm
by Paulo11
I don´t know that the trigger are on clutch side