Ecumaster forum

Hi,

Im new in the EMU world.
tryring to get a fiat 1.8 16v to run..

just wire it in.
setting up the ecu now.

can some one please look at the trigger settings i shoul use?

cheers

the rotation is the wrong way on in the pic!...

No one?

I was thinking...
2e tooth..
65 degrees.

that is a weird pattern, maybe the gurus from ecumaster will have another idea, but i would use a simple 36-1 or 60-2 trigger wheel.
cant you fit like a pulley from fiat punto 1.1? it already have a 60-2 trigger wheel on it

It's the same as a Subaru 6 tooth.
And that one is supported by the emu

Just need to know what to put in as the trigger

No one else?

Is it Fiat Stilo ?

It looks the same as subaru.

So I would give a try the following settings:

car is a Barchetta


this is the scope i got now.
and the settings

Please try my settings. Should work. Of course check the spark with the timing lamp.

The car does not have timing marks.

Have to make my own.

I can not get her to fire up..

Timing is not in the same place every time.

Seems like its using a different start position?

Btw..

The rotation is the picture is the good way

this is the scope.

with the subaru 6 tooth settings i get a lot less triggers.
plus in the manual it say that it does not work with cam sinc..

so should i go group injection and wasted spark?

The scope looks ok. This signal is converted to 2 tooth per revolution.

It works with cam sync. I sent you configuration.
You have to use cam sync otherwise it will not work.

Oke thanks.

Car is a
Fiat Barchetta
1.8 16v.
360cc injectors.
Turbo

Can you please send it to
R.akkermans@esra-carperformance.com

Thanks

Hello Sir.


Did you send the file already?

Desperate to try.

Want o test it tomorrow morning.

Really need that file