Page 1 of 1
Can Bus connecting
Posted: Sun Feb 28, 2016 2:50 pm
by DT-GT42
Hello
Anyone has a can Bus Wiring Diagramm ??
Greetz
Re: Can Bus connecting
Posted: Sun Feb 28, 2016 5:44 pm
by Karel
GND
CANH
CANL
Re: Can Bus connecting
Posted: Sun Feb 28, 2016 6:20 pm
by DT-GT42
Yes but which connector is what ?
In the Emu are 4 connectors
Re: Can Bus connecting
Posted: Sun Feb 28, 2016 8:59 pm
by roquete
you will need the can-bus module, its connected to the serial port (round 5 pin), then on the can-bus module there is the 6 pin round plug and the pinout is at EXT. PORT / GENERAL help