Denso coil convert
Posted: Sun Dec 09, 2018 4:04 am
Need assistance from anybody
Plan to convert coil (using Denso 90919-02248) on 2JZ-GTE engine
Where pinouts should be wired?
From Denso 90919-02248 coil pinout:
1 - 12V (to battery or to EMU?)
2 - Signal (to ECUMASTER EMU)
3 - Tacho (to where)
4 - Ground (to engine block?)
What about setting of:
- Coil dwell wizard (which one to use)
- Coil dwell time
- Ignition outputs (sequence)
Plan to convert coil (using Denso 90919-02248) on 2JZ-GTE engine
Where pinouts should be wired?
From Denso 90919-02248 coil pinout:
1 - 12V (to battery or to EMU?)
2 - Signal (to ECUMASTER EMU)
3 - Tacho (to where)
4 - Ground (to engine block?)
What about setting of:
- Coil dwell wizard (which one to use)
- Coil dwell time
- Ignition outputs (sequence)