Page 1 of 1
idle valve 2JZ-GTE
Posted: Tue Aug 19, 2014 11:58 pm
by lom51
Hello!
How to connect and configure the idle valve on the engine Toyota 2JZ-GTE?
Re: idle valve 2JZ-GTE
Posted: Wed Aug 20, 2014 11:51 am
by Jadzwin
Hi!
Please find attached wiring diagram.
Re: idle valve 2JZ-GTE
Posted: Wed Aug 20, 2014 3:43 pm
by lom51
Idle-Parametrs-unipolar stepper - not active...
Re: idle valve 2JZ-GTE
Posted: Wed Aug 20, 2014 4:04 pm
by PSI-Motor
Close down the idle parameter view to the left in the picture and open it again then it should go active.
Re: idle valve 2JZ-GTE
Posted: Wed Aug 20, 2014 4:19 pm
by lom51
Ok, thanks!
Now outputs - "not assignet" and stepper not working...
Re: idle valve 2JZ-GTE
Posted: Wed Aug 20, 2014 4:47 pm
by Jadzwin
Hi!
Please check if there is idle control active 1 on the log or in idle log group window.
Your configuration seems to be ok. The fact that there is no assigned outputs in assigned outputs window is a bug (outputs are assigned for sure, bug is already fixed).