Ecumaster forum

Hello

After upgrade of firmwire, my 2jz will not start... It was starting perfect before upgrade..
First i downloaded the new version of software from the website, and then i upgraded the firmwire on the ecu..

Can you check if there is anything in my map i have done wrong?

I got this message after upgrade:

"Loading project warning log.
Error: Cannot find table boostDCTable in current project. Skipped.
Error: Cannot find table etcOpenOverRevs in current project. Skipped."

Can it have some influence ??

For what firmware version did you upgrade ? And from what version ?

Jadzwin wrote:For what firmware version did you upgrade ? And from what version ?

1,016 before to 1,100 now

My software is 1,100 on my pc.. Cant remember last version...

Can it maybe have something to do with Knock Sensor?

PLease send us your map and the log file to tech(@)ecumaster.com

Jadzwin wrote:PLease send us your map and the log file to tech(@)ecumaster.com

Email sent!

Hi!

For 2JZ VVTi we changed the CAM decoder to improve engine start.
Here is a document how to setup trigger and VVTI
https://dl.dropboxusercontent.com/u/286 ... e_vvti.pdf

If you have any issues please let me know.

Jadzwin wrote:Hi!

For 2JZ VVTi we changed the CAM decoder to improve engine start.
Here is a document how to setup trigger and VVTI
https://dl.dropboxusercontent.com/u/286 ... e_vvti.pdf

If you have any issues please let me know.

Thx ! I will try my best