Ecumaster forum

hi
I have severe misfires between 6000-8000 rpm.
the gear is Neutral. I tried it on the street - same.
I changed the coils, spark plugs, injectors.
it was running full sequential. I changed it to wasted spark and semi sequential.
result is : same.

Hi

Have you tried more fuel and less ignition. I runs a bit lean
What engine is it ?

Br Lasse

I tried every kind of fuel from 11:1 AFR to 15:1 afr
or
more and less ignition too.
doesnt matter.

and by the way : the car is not moving. it's in NEUTRAL gear.

whats the crank sensor on it ?

bosch VR sensor

is it new sensor ??
we had same problem with a vr sensor worked fine but high rpm it would miss fire so put a new one in it and it would be fine but vr sensors are not very good at high rpm i believe anything over 7500 they play up according to Bosch data

I'm changing the vr sensor tomorrow.

I don't see any trigger errors, but I normally don't see them recorded in log unless the advanced filter is turned on. also pull a scope when the misfire is occuring. enable it in Primary trigger, and hold down the blue arrow button to record. scope window is in log menu tree. There are several good filters in the EMU for dealing with weak/noisy VR sensors.

Why is Warm Up enrichment below 100%? you have set to 80 at the current coolant temp you are running.

What Firmware version are you using?

The problem is solved. Bad vr sensor. Fw is 1.19 exp

glad it sorted it out

is doesnt always show up thats its a bad sensor on the logs but 80% of the time at high rpm its usally the sensor at fault