Ecumaster forum

There is vss input b14 pin but in emu software it cannot be selected , you can chose between 4 analog input only , why is that and which pin to use

For what function do you want to use VSS ?
In general you can use it for VSS sensors or FlexFuel sensor.

I want to use it for speed loginng and traction control in future if needed

Just setup sensors / vss and gearbox parameters

I set it as hall sensor , use resistor pullup , plug it on analog input 3 , set gearboz ratio , but none signal appear on log vss freq .. tomorow will test again

You need connect sensor to VSS input pin.
Analog inputs are only for gear sensor. You have to use strategy "caluclated"

Press F1 on the parameters window. Everything is described there

Sorry my mistake I read it wrong in help ...