Page 1 of 1
DBW
Posted: Wed Jun 03, 2015 10:03 am
by RHD
So how do we connect this throttle??
it is from an Australian ford 6 cyl
Re: DBW
Posted: Mon Dec 14, 2015 4:02 pm
by RHD
Just bumping this thread
i still need to find the settings for this DBW hrottle body. I have a customer trying to set this up right now and had a lot of interest for them in Aus they are a 4.0L turbo 6cyl ver popular and ideal candidate for EMU ecu
Re: DBW
Posted: Mon Dec 14, 2015 7:55 pm
by PSI-Motor
Is this the one?
Re: DBW
Posted: Mon Dec 14, 2015 8:00 pm
by Wuniek
RHD wrote:Just bumping this thread
i still need to find the settings for this DBW hrottle body. I have a customer trying to set this up right now and had a lot of interest for them in Aus they are a 4.0L turbo 6cyl ver popular and ideal candidate for EMU ecu
Hi,
i looked a little bit for it and i assume it will bit easier if you will put more info in first post:
THROTTLE BODY FG FALCON 6CYL
PART # 8R29-9F991-AA
foto is always good thing to add but i will prefer to see something like this :
then pin out or data sheet is needed to tell more...
and from there i cannot help you, all data i found is on Australian forums ( for registered users), i didn't find any replacement number for it
then typically that particular throttle body model should be send to Ecumaster for testing and setting up proper parameters for it, and this something i think hard to skip as you don`t want any strange
behavior on your throttle
and last one you need Ecumaster DBW module ( and it is not designed for road usage )
Re: DBW
Posted: Tue Dec 15, 2015 3:29 pm
by RHD
Thank you PSI-Motor im sure that will be helpful
Yes sorry Wuniek, I know i should have added more info but its not my vehicle and i dont actually know a great deal about it all i have is the picture of the throttle body part number that another customer sent. The customer is using the DBW module and has it all hooked up and sort of working but its not very satisfactory, so he must have the correct pin connections already we just have to configure the settings somehow.
Re: DBW
Posted: Tue Dec 15, 2015 6:33 pm
by Wuniek
so if you are on stage where device is mounted and willing to work, i will send project and logs to Ecumaster team for verification
personally if i would be in your situation i will just buy this part and send it directly to Ecumaster and wait for update from them
never the less all info thats is really needed posted PSI now someone knowable need to interpret this data and propose setup for further testing