Ecumaster forum

Hi,

I want to fit a new rev counter (tacho), the wiring is that i need to give green cable to the signal of the RPM.

Does anybody knows what signal of RPM i need to wire on the EMU? (wire for RPM output)
Can i just use analoge input maybe..?

Thank you very much!!

shadowlandz wrote:Hi,

I want to fit a new rev counter (tacho), the wiring is that i need to give green cable to the signal of the RPM.

Does anybody knows what signal of RPM i need to wire on the EMU? (wire for RPM output)
Can i just use analoge input maybe..?

Thank you very much!!

Use any aux and configure it under outputs. Standard is aux 4.