Page 1 of 1
EMU + RACPAK IQ3
Posted: Tue Mar 08, 2016 8:20 pm
by Johnny Borg
Hi.
How do i make this things to work together?
And not only the RPM signal
RACEPAK IQ3
http://www.racepak.com/Components/IQ3_Display.php
Re: EMU + RACPAK IQ3
Posted: Wed Mar 09, 2016 1:43 pm
by Jadzwin
Hi!
We run Racepak dash using CAN and Haltech protocol (as I good remember)
Re: EMU + RACPAK IQ3
Posted: Wed Mar 09, 2016 4:12 pm
by Johnny Borg
Ok, thats sounds nice.
How should i connect it and pinout?
DO i need a can converter?
Re: EMU + RACPAK IQ3
Posted: Wed Mar 09, 2016 4:30 pm
by Jadzwin
You need CAN module. You need to connect CANL to dash CANL and the same with CANH...
Termination resistor 120Ohm will be required between CANL and CANH