Ecumaster forum

Hey guys, it's me again

I want to run a Vw ABF 16V in full seqential mode non turbo, 9000 UPM. Crank trigger is 60-2. But what to do, to get a good signal of the cam position?
I've got a 4-window distributor, is it possible to get it running as secondary trigger? How?

Any other ideas to get a signal of the Cam position? I thought about triggering the cam wheel, is that possible, if I would mill one Teeth away ( just ahead of the Sensor, not a whole teeth).

Thanks a lot

I made last year an 16V Turbo and cut 3 of the 4 teeth off. So then i had only one teeth and uses this as cam trigger.

Kannst du mir mal privat schreiben?

Thanks for the qiuck answer, any other ideas?

Hast du einen Verteiler vom 1.8 16V drin?ABF hat doch normalerweise nur ein Fenster

You use Distributor from 1.8 16V?

mfg
Daniel

You can also remove just one tooth from the cam trigger wheel to get 4-1 pattern

It's a 4 window Dizzy.

I will remove 3 of 4 Flaps.

There are two types of ABF Dizzys...How ever it's a 4 window trigger.

Thanks alot

Vielen Dank