Ecumaster forum

Hello,
Have a problem wiring my DBW module, actually DBW is not a problem to connect, problem is in accelerator pedal signal to ECU , as i understand i should connect signal wire from accelerator pedal to ECU TPS in pin. But i have two signal wires from accelerator pedal. So how could i do now ? In attachment i added diagram of ecu and accelerator pedal connection and pin descriptions.

Use D8

PSI-Motor wrote:Use D8

I used D8 as TPS in and D7 as sensor ground for pedal position sensor, When i turn ignition on there comes whistle sound from throttle body is that ok ? Also i have VDO 408238424001 throttle body, when i choose it and sellect all inputs in software, when i turn ignirion off and turn it on again, all settings stay the same but throttle body wizard is changing my VDO to BMW 40823842500.

When i turn ignition on i have same noise as on this video.
https://www.youtube.com/watch?v=IU1qAEBJxAM

Bimmer wrote:When i turn ignition on i have same noise as on this video.
https://www.youtube.com/watch?v=IU1qAEBJxAM

Looks like its normal. The frequency of this sound should be same like frequency o changing polarity of the electromotor. So you are basicly very fast opening and closing the plate... And this make s this sound... i think.